1. Audio Glossary of Terms
(Technical/Definitions)

... pre-amplifier is passed through an electronic crossover and divided into two separated signals. These signals are sent to the respective amplifiers and their outputs are sent to the respective speakers.(bass ...

2. Download - 2-way Passive Crossover Network Calculator
(General/Downloadables)

Design Calculator for 2-way Passive Crossover Networks Want to build a custom set of splits and need a custom crossover, or just dont like the frequencies of your factory ones? The expensive option is ...

3. Build Your Own Basic Speaker Crossovers, Coils and Capacitor Size Table
(Electronics/Car Audio Electronics)

Build Your Own Basic Speaker Crossovers Low Pass: Filter ABOVE the frequency, use COILS High Pass: Filter BELOW the frequency, use CAPACITORS   Use this table to determine capacitor size (must be ...

4. Crossover Orders, 6 decibels of separation
(Technical/Theory and Physics)

Crossover Orders, 6 decibels of separation So whats a crossover ? Once set, it attenuates the frequencies either above it (low pass) or below it (above it). Wait that doesnt make sense you say, but it ...

5. Kicker Announces 2010 ZX Series Amplifier Models
(News/Latest)

... efficient chassis, ZX Sub Amps offer a 24dB/octave low-pass electronic crossover and a 24dB/octave, high-pass subsonic filter fixed at 25 hertz. All have up to +18 decibels of boost centered at 40 hertz, ...

6. KICKER® DX-Series Amplifiers New-for-2010
(News/Latest)

... including the ability to be stable under loads as low as one Ohm. DX Sub Amps are rated at 1,000 watts or 500 watts (1 Ohm at 14.4V), offering an 18dB/octave low-pass electronic crossover variable from ...

7. Car Audio on a Budget, The $1000 System
(Install/Car Audio Installation)

... may require an additional adaptor for an IPod), I have provided links to those models too. All of these models come with some type of detailed sound tuning ability, for example low/high pass crossovers ...

8. Setting Amplifier Gains
(Electronics/Car Audio Electronics)

Setting Amplifier Gains After reading our article on how to setup and use your CRO, you're probably wondering how to apply this to tuning an amplifier system.. read on. For this you'll need: A CRO ...

9. Thiele-Small Parameters: What your subs specs sheet REALLY means
(Technical/Definitions)

...  Ras: Acoustical equivalent of Rms Res: The electrical resistive equivalent of Rms, in ohms Revc: DC voice coil resistance, in ohms Rg: Amplifier source resistance (includes leads, crossover, ...

10. Eliminate Engine Noise
(Electronics/Auto Electrical for the Car Stereo)

... Assuming your RCAs aren't the problem plug them back into their source. Now disconnect the RCAs going into this source and replace them with shorting plugs. If you don't have a processor or crossover then ...

11. Inverting Subwoofers
(DIY Articles/Car Audio Do It Yourself)

... speakers will interfere and make crossover frequencies quieter. 2. You want the bulk of the cable hidden in the box. 3. You want to see the minimum of cables on the sub. So lets do this ! I'll use ...

12. Subsonic, what is it and how do I adjust it ?
(Electronics/Car Audio Electronics)

A subsonic filter is basically a High Pass Filter for very low frequencies, generally 45hz or lower. That is, whatever you set it at; only frequencies above that setting go through. Anything below that ...

13. 1968 Ford Mustang GT - Car Audio Install
(Install/Car Audio Installation)

... MTX front splits installed. After taking the photo i decided to re-locate the crossovers as there really wasnt enough room to neatly fit them in there. The splits were mounted on 12mm MDF with  custom ...