1. Audio Glossary of Terms
(Technical/Definitions)

... the highest analog frequency during the digital encoding of an analog signal.       • Alternate-Channel Selectivity - A measurement of a tuner's ability to select one radio station's signal and reject ...

2. Honda Acura Check Engine Light CEL Codes OBD0 OBD1 & OBD2
(DIY Articles/Performance Do It yourself)

... sensor 10 IAT - intake air temperature sensor 12 EGR - exhaust gas recirculation lift valve 13 BARO - atmospheric pressure sensor 14 IAC (EACV) - idle air control valve 15 Ignition output signal  ...

3. How to use an Oscilloscope (CRO) to identify clipping
(Electronics/Car Audio Electronics)

... headunit is running unclipped before you start Q. Do I need to run test tones? Can’t I use music instead? A. No. Music doesn’t give a clean, clear signal and makes it hard to identify the trace. You ...

4. DIY Clear Turn Signals
(DIY Articles/Performance Do It yourself)

DIY Clear Turn Signals  Clearing your front turn signals will give your car a much cleaner appearance. The general modification process is similar for most vehicles. The install normally involves ...

5. Kicker Announces 2010 ZX Series Amplifier Models
(News/Latest)

... may surge down the line, so listeners enjoy the cleanest, clearest sound possible. Additionally, a choice of three automatic turn-on modes (remote, DC offset, signal sense) provide ultimate flexibility. ...

6. KICKER® DX-Series Amplifiers New-for-2010
(News/Latest)

... (remote, DC offset, signal sense) provide ultimate flexibility. The DX200.4 Four-Channel Amplifier gives the listener multiple channels for a choice of installation configurations. It provides 50 watts ...

7. Desolder and Test the Field Effect Transistors (MOSFET) in your amplifier
(Electronics/Car Audio Electronics)

... the one which beeps when you touch the probes together. First you need to Arm the FET. Place the -ve electrode on the center pin (drain) and the +ve on the left pin. You should get no signal (Open Link ...

8. Ohms & Impedences, How to Select the correct amplifier and load
(Electronics/Car Audio Electronics)

... to use a mono (single channel) configuration, especially with duel voice coils. Attempting to connect 1 coil to each channel, instead of bridging the amp, can result in burnt out coils as stereo signals ...

9. Eliminate Engine Noise
(Electronics/Auto Electrical for the Car Stereo)

... usually used where our engine is providing the electrical power through an alternator. An alternator puts out an AC signal with quite a large amount of current. This is then rectified and placed on our ...

10. 1968 Ford Mustang GT - Car Audio Install
(Install/Car Audio Installation)

... properly separating the power / earth and signal (RCA) cables essential for minimizing any engine noise / interference. This last pic shows the other side of the board above, the home for the systems' ...