1. Headunit Installation in 2002-2006 Lancer
(Install/Car Audio Installation)

... Pull the stereo outwards carefully, once you’ve got it out far enough to reach behind it, unplug the main wiring loom by pressing on the pin in the centre of the plug and pulling away from the unit. Also ...

2. Ohms & Impedences, How to Select the correct amplifier and load
(Electronics/Car Audio Electronics)

... for "free" just by bridging your 4ohm speakers ! Series Wiring: When speakers, or Duel Voice Coil subwoofers, are wired in Series, it means one +ve & -ve are connected to each other, and the remaining ...

3. Installing a Head-Unit Into a VT-VX Commodore
(Install/Car Audio Installation)

... the unit (including the antenna plug). Â Â Step 3: Wiring the new loom into the old. This step will explain how to "splice" your new stereos wiring into the factory loom, without cutting off ...

4. Installing a Head-Unit into a 2002 Subaru Forester
(Install/Car Audio Installation)

... of the facia until It pops free, there are no screws holding it on now, so just take your time and it will come out (with the control cables still connected). Once thats done, you can unplug the wiring ...

5. Head - Unit Removal and Installation - 2003 Mitsubishi Magna
(Install/Car Audio Installation)

... unclipped this panel, remove the wiring / plugs from the rear of it: Step 3: Remove Stereo / AC Facia panel. This one requires a little bit of patience and skill to get off successfully. First "mini" ...

6. VIDEO Subwoofer Wiring, Parallel, Series
(Electronics/Car Audio Electronics)

VIDEO Subwoofer Wiring, Parallel, Series This is a sister article for this one.. switched up with video demonstration ! So, if you want to learn how to wire your subwoofer in series, or in parallel, ...

7. Standard Aftermarket CD Player Wiring Colors
(Electronics/Car Audio Electronics)

Standard Aftermarket CD Player Wiring Colors Yellow: constant power Red: switched power Black: ground Orange/white: illumination Blue/white: amp remote turn-on Blue: power antenna Speakers: solid ...

8. Standard Aftermarket Headunit Wiring Colours
(Electronics/Car Audio Electronics)

Standard Aftermarket Headunit Wiring Colours Did you know there's a standard for all aftermarket source unit wiring colours ? Well there is and here it is: Memory / Constant 12V(+) Yellow Switch ...

9. Front speakers in an SF5 forester.
(Install/Car Audio Installation)

... in a similar fashion to the sail panel. The plug for the wiring loom on the back of the switch panel can be quite stubborn to remove, a flat blade screwdriver can be of use here. Then undo the ...

10. A Guide To Relays
(Electronics/Auto Electrical for the Car Stereo)

... an appropriate fuse, all my wiring diagrams include the appropriately - sized fuse/s.) Â DRIVING / FOG LIGHTS Here i have provided a simple wiring diagram and information about wiring up aftermarket ...

11. Car Audio on a Budget, The $1000 System
(Install/Car Audio Installation)

... getting a rough job are minimal. I would imagine if you were to buy all, or even most of the components from the same place that’s going to install it that a cost of $300 - $450 including wiring is about ...

12. Capacitors tested in a real world enviroment
(Electronics/Car Audio Electronics)

... cars electrical system is being taxed beyond what the factory wiring can handle! Dont believe me, read on for real world testing of power capacitors in a car audio system.. The Test System:   ...

13. 1968 Ford Mustang GT - Car Audio Install
(Install/Car Audio Installation)

... to hold the MTX 4ch. amplifier. Note the extra care taken to tidy up the wiring, this not only looks good (whos going to see it though?) but makes the wiring simpler and easier to identify, not to mention ...

14. Sentra Installation (step by step gallery)
(Install/Car Audio Installation)

... of 0g 0|ap120.jpg|Wiring Harness|Positive power feeds for the amplifier 0|ap121.jpg|Earthing|Earthing points in the rear near amp 0|ap122.jpg|All installed|Box, amp, subs, and caling all installed ...

15. DIY Clear Turn Signals
(DIY Articles/Performance Do It yourself)

... Under those flaps are short metal braces that attach to the bottom of the valence.  Remove the nuts/bolts that connect it to the valence. Unplug the wiring from the fog lamps Remove the screw type ...

16. Eliminate Engine Noise
(Electronics/Auto Electrical for the Car Stereo)

... the RCA inputs from the amplifier and place the shorting plugs on all channels. Turn your system on. Has the noise disappeared? If it has then the amplifier and the associated wiring is OK and we can move ...

17. Headunit Installion in X2-X3 Hyundai Excel & Accent
(Install/Car Audio Installation)

...  For wiring, I recommend buying an adapter with flying loom as they are readily available for under $15. Â Re-installation is the reverse of removal. Ensure to clip the control cables back in their ...

18. Sealed vs Ported (tested)
(Technical/Theory and Physics)

... wiring harness  Test Equipment: Digital Multimeter Goldline DSP-30 RTA  Test Method: Amp hooked up to CRO, gains adjusted @ 60 Hz until clipping, and then backed off. LP Xovers set to ...

19. Weight Reduction Guide
(DIY Articles/Performance Do It yourself)

... carpet lining underneath will reduce the cars overall weight by close to  40lbs.  Removing excess wiring and bolts and brackets will also net you a reduction of close to 10lbs.    Battery - swapping the ...

20. Metal types compared, whats best for audio systems ?
(Electronics/Auto Electrical for the Car Stereo)

Metal types compared, whats best for audio systems ? Ever wondered why some metals are better for audio use? Here's their metalurgical and electrical properties.. lower resistance is better, higher conductivity ...